106 products
Sale
Quick view
Sale
Quick view
Sale
Quick view
Sale
Quick view
Sale
Quick view
Sale
Quick view
Sale
Quick view
Sale
Quick view
Sale
Quick view
Sale
Quick view
Sale
Quick view
Sale
Quick view
Sale
Quick view
Sale
Quick view
Sale
Quick view
Motor wheel cover/cap for Backfire Electric Skateboards
Sale price
$8.00 USD
The most common used hardware for Backfire Electric Skateboards, please select the right model for your board. Feel free to contact our support if any questions.
Motor covers for G3 & Mini (Also could be used on G3 plus, G2 Black and G2 Galaxy after June 2020)
Motor cover for G3 Plus (Also could be used on G3, Mini, or G2 black & G2 Galaxy)
The 1st generation G2 black motor cover with bearing and magnets (for G2 BLACK made before June 2020, please check with our support if you are not sure which version you had):
Motors for Backfire Ranger X3
Regular price
$329.00 USD
Sale price
$319.00 USD
Save $10.00 USD
Replacement Motors for Ranger X3，equipped with 9 pin cables, do not fit on Ranger X2 or Ranger X1.
Updates: If you received your Ranger X3 after June 1st 2022, the motors and esc in ranger X3 have been updated from original 29 kv to 33kv. Make sure you order the correct motors for replacement. If you have any questions, please reach out to our tech support.
Mudguards for Backfire Hammer and Sledge
Sale price
$69.99 USD
The mudguards are designed for Backfire Hammer and Hammer Sledge specially. It is slightly different from the mudguards on Ranger for the different truck set up . So please make sure you select the right model.
Disclaimer:
Mudguards does not change the water resistant level of Backfire Boards. It is used for small amount of water or muddy terrains. Backfire's IP55 water-resistant rating enables riders to use the board through a small puddle on most dry roads. You cannot use the board during the rain, or on wet/icy grounds after rain & snow; or sink the board into the water. Water could damage your battery, esc, motors, and the bearings in the wheels. Water damage is NOT covered under our warranty.
Power button & cable for Backfire Boards
Regular price
$12.00 USD
Sale price
$10.00 USD
Save $2.00 USD
The power button is a critical small part to start your board. In case, you need to replace the power button. We offer it with a low cost.
Disclaimer:
The Power button which works with Hobbywing ESC is different from the power button which works in 2017 original G2.
The power button for G3, G3 plus and Zealot contains an extra cable for the light control system.
Mini has a smaller power button from other models.
Since late June 2020, we updated ESC enclosure so the power button is different form previous version, the new power button will be all the same style like in the Mini which is smaller. In addition, to simplify the system, the light control cable for (G3, G3 plus, and Zealot) is also removed from power button (directly built in with the ESC).
The old Esc power button is bigger, and for g3 ,g3 plus and zealot (before June 2020), there is a light control white plug
The New Esc power button for all current models, is smaller. There is no light control plugs for zealot, g3, g3 plus or zealot s needed.
