- Fixed speed road cruise
- Eco mode, Sport Mode, Turbo Mode(with 30 seconds limit)
- Board status display: mode, speed, range, battery, connection, Odometer.
- Speed and range unit setting: miles or kilometers
- Wheel diameter setting: 83mm ,96mm or 165mm
R2x remote does NOT work for Ranger X1 or any previous models like : G2T, G2 Black, or G2S, which is in different signal channel.
- 2.4G Radio
- Rechargeable battery
- 2 Speed Mode
- Forward and Backward two direction switch
- Battery Indicate lights
FAQ for the remote:
Q: How to pair the new remote to the board?
When the power button on the board is flashing quickly, press and hold the power button on the remote, after about 5 seconds, the remote will pair to the board.
Q: How to change the speed mode on the remote?
When you fully stop the board (you can not during the riding), press the 2nd button on the remote, the light on the remote will flash in slow/ quick mode on the remote, which indicates the speed mode of the board.
Q: How to tell the battery life on the remote?
With a short press of the power button on the remote, the light will light up to show you the battery life: Four lights means full battery, 3 lights means above 80% of battery, 2 lights means above 60% of the battery and 1 light means around 35% to 0% of the battery.
Q: Why my first two lights dropped quicker than the last two lights ?
The light is not very accurate in evenly showing the battery life. The first two lights are about 35% of the battery, the 3rd light is about 30%, the last light is showing about 35% of the battery after some study.
Q: How to tell the battery is low?
- 1. When the battery is below 25%, the remote light turn from green to red and stays on, vibrate once
- 2. When the battery is below 10%, the remote red light will start flashing , will vibrate twice
- 3. When the battery is below 5%, It will vibrate twice again.
- Then the battery will be complete out , the remote will vibrate once and the board will shut down
All different screws and hardware for Backfire skateboards including: G2S , G2T, and G3.
Each photo contains the UOM of 1 set, and sell as set. For example: If you buy 1 set of M6*16MM screws for battery or ESC case, you will get 6 pcs ( 1 set) showing in the photo.
Please reach out to our Tech support via email （email@example.com）for more details or questions.
- The advanced BMS system can protect the skateboard battery from braking when it is full of electricity and will not cut off electricity.
- 6.0ah, 36V, 216Wh
- Each cell is protected by a special bracket, so to protect the battery while skateboarding on rough roads.
- Dimension of the battery itself: 5.8 inch * 4.0 inch * 1.7 inch
- Enclosure size: 10.7 inch * 7.4 inch * 2 inch
- Screws are not included ( showing in the photo for demo only)
- The wrap color might be changing from batch to batch: black, blue or golden. The most recent batch should be black wrap
- BRAKE SENSE: When the brake is sensed, the smart tail light automatically switches to the brake light mode. Cause the attention of the rear vehicle, IMPROVE SAFETY
- BRIGHTNESS: 180-Degree field of view width. It's super bright especially you brake and in dim to no light conditions for anyone to see your rear all clearly visible for night no matter rain or fog
- AUTO ON/OFF: An intelligent sensor provide AUTO ON/OFF for the tail light.20+hours run time,even you needn’t to charge it within one week,never worried about running out of power, ENJOY THE FUN OF RIDING
- IPX6 WATERPROOF: IPx6 waterproof and dust-proof, water spray from any direction will not enter the light.
- AUTOMATICALLY START AND STOP : With a intelligent sensor, the tail light will turn on automatically riding in low brightness and turn off automatically riding in high brightness. Also the tail light will turn on when braking.